Home / Insights

Studio LED strip lighting: how many LEDs and what power supply you need

Addressable LED strips turn a plain studio into a set. Planning them takes three numbers: wall length, strip density and how much current the strip can draw.

Addressable strips such as the WS2812B let every LED show its own colour, which is what makes effects, gradients and music-reactive lighting possible. They also draw far more current than most people expect, and a strip that is planned badly flickers, turns yellow at the far end or overloads its power supply.

1. Count the LEDs

LEDs on a wall = wall length in metres × strip density in LEDs per metre. Common densities are 30, 60, 96 and 144 LEDs per metre.

StripFour 3 m walls (12 m)Good for
30 LEDs/m360 LEDsIndirect lighting behind a ledge or diffuser
60 LEDs/m720 LEDsVisible strips and smooth effects, the usual choice
144 LEDs/m1728 LEDsShort accent runs; too many for a whole room on one controller

Skip walls with a door, window or wardrobe. LED Studio lets you set any wall to zero LEDs, and drives up to 1000 LEDs from one controller.

2. Work out the maximum current

A WS2812B LED can draw about 60 mA at full white, because each of its red, green and blue parts draws about 20 mA. So:

Maximum current = number of LEDs × 0.06 A. For 720 LEDs that is about 43 A at 5 V, more than 200 W.

Real lighting rarely runs every LED at full white. Colours, effects and lower brightness draw a fraction of that, which is why a controller should cap the total current in software. LED Studio limits power to 5 V and 12 A by default and caps brightness at 200 of 255, so a 720-LED room never asks for the full 43 A.

3. Size the power supply

  • Use a 5 V supply rated at least 20% above the current cap. For a 12 A cap, choose 5 V and 15 A or more.
  • If you raise the cap for brighter white light, size the supply for the new cap, not for average use.
  • Use a supply from a reputable maker with short-circuit protection, and fuse each power run.

4. Inject power at the corners

The copper in a thin strip has resistance, so voltage falls along a long 5 V run. The far end turns dim and yellow-red, because blue and green need more voltage. The fix is power injection: run thicker wires from the supply to the strip at several points. For a room, feeding power at each corner works well.

  • Connect the grounds of the controller, strip and supply together.
  • Keep the data wire from the controller to the first LED short.
  • A resistor of a few hundred ohms in the data line and a large capacitor across the supply at the strip are widely recommended for reliability.

5. Plan it once, in the app

The LED planner in LED Studio does these sums for you: enter the wall lengths and strip density, and it shows the LEDs per wall, strip length, maximum current and power supply size, then applies the layout to the device.

Mains wiring for power supplies should be done by a qualified electrician. These are planning guidelines, not an electrical design.

Lighting a studio or building a lighting product?

LED Studio plans and controls addressable LED strips over Bluetooth from a phone or PC. We also build custom connected devices.

Start a conversation See LED Studio